In an earlier change we switched to defining our own sets of detectors,
getters, etc for go-getter in order to insulate us from upstream changes
to those sets that might otherwise change the user-visible behavior of
Terraform's module installer.
However, we apparently neglected to actually refer to our local set of
detectors, and continued to refer to the upstream set. Here we catch up
with the latest detectors from upstream (taken from the version of
go-getter we currently have vendored) and start using that fixed set.
Currently we are maintaining these custom go-getter sets in two places
due to the configload vs. initwd distinction. That was already true for
goGetterGetters and goGetterDecompressors, and so I've preserved that for
now just to keep this change relatively simple; in later change it would
be nice to factor these "get with go getter" functions out into a shared
location which we can call from both configload and initwd.
It is common for the same module source package to be referenced multiple
times in the same configuration, either because there are literally
multiple instances of the same module source or because a single package
(or repository) contains multiple modules in sub-directories and many
of them are referenced.
To optimize this, here we introduce a simple caching behavior where the
module installer will detect if it's asked to install multiple times from
the same source and produce the second and subsequent directories by
copying the first, rather than by downloading again over the network.
This optimization is applied once all of the go-getter detection has
completed and sub-directory portions have been trimmed, so it is also
able to normalize differently-specified source addresses that all
ultimately detect to the same resolved address. When installing, we
always extract the entire specified package (or repository) and then
reference the specified sub-directory, so we can safely re-use existing
directories when the base package is the same, even if the sub-directory
is different.
However, as a result we do not yet address the fact that the same package
will be stored multiple times _on disk_, which may still be problematic
when referencing large repositories multiple times in
disk-storage-constrained environments. We could address this in a
subsequent change by investigating the use of symlinks where possible.
Since the Registry installer is implemented just as an extra resolution
step in front of go-getter, this optimization applies to registry
modules too. This does not apply to local relative references, which will
continue to just resolve into the already-prepared directory of their
parent module.
The cache of previously installed paths lives only for the duration of
one call to InstallModules, so we will never re-use directories that
were created by previous runs of "terraform init" and there is no risk
that older versions will pollute the cache when attempting an upgrade
from a source address that doesn't explicitly specify a version.
No additional tests are added here because the existing module installer
tests (when TF_ACC=1) already cover the case of installing multiple
modules from the same source.
Unlike the old installer in config/module, this uses new-style
installation directories that include the static module path so that paths
we show in diagnostics will be more meaningful to the user.
As before, we retrieve the entire "package" associated with the given
source string, rather than any given subdirectory directly, because the
retrieved module may contain ../ references into parent directories which
must be resolvable after extraction.
Alisdair McDiarmid